Can't enumerate the entire bus

[linuxboy]

Hi all,
Last night I finally got CAN working reliably (or so I thought). This morning I came in and decided to write code for using the Jags on the cRIO instead of just using BDC-COMM. Somewhere when testing I started to get errors about a firmware version being 0. I connected it to BDC-COMM again and found that it wasn't enumerating the second jag on the bus. I switched the order that the Jags were wired and it recognized the one that became the first Jag after the switch (the one that wasn't getting enumerated before). Then I tried using 3 Jags and was able to (unreliably) read the second but not the last jag in the chain.

Any ideas guys?

Thanks