pneumatics help please.

[wilsonmw04]

Originally Posted by Mark McLeod

Yes.

Is your SMC a 12v or a 24v model?
Make sure your solenoid breakout is powered by the correct matching voltage.

you can have 24 volts off the breakout? I did not know that! I thought the only use of the 24 volt output of the PD was fro the Crio.

[IndySam]

<R38> A. The cRIO-FRC power input must be connected to the 24 Vdc supply terminals on the PD Board. With the exception of one Solenoid Breakout Board, no other electrical load can be connected to these terminals.

[wilsonmw04]

Originally Posted by IndySam

<R38> A. The cRIO-FRC power input must be connected to the 24 Vdc supply terminals on the PD Board. With the exception of one Solenoid Breakout Board, no other electrical load can be connected to these terminals.

wicked. thanks :-)