|
|
|
 Competition is only the path that FIRST takes to bring science, engineering, and technology to the masses. - Pavan Dave [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Competition is only the path that FIRST takes to bring science, engineering, and technology to the masses. - Pavan Dave [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: I can run the Labview code, but it doesnt do anything
just figured out the problem! turns out the v27 image on the crio was bad. doesnt match up with pre-3.1 labview firmware. go figure. uploaded v28 that i got from FIRST Forge (http://firstforge.wpi.edu/sf/sfmain/...ectedTab=files) and everything works fine now
Last edited by Team2191 : 14-02-2011 at 20:20. 
|
|
#2
15-02-2011, 15:32
|
|||
|
|||
|
Re: I can run the Labview code, but it doesnt do anything
Quote:
    
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
