Using a 3 volt gyro

[kgzak]

we bought a gyro but the input is only 3 volt. We are not to worried about the input but the fact that the standard voltage is 1.35. How do we read this in Labview?

Thanks

[Joe Ross]

In the gyro open, it measures the average voltage for a period of time (I think I remember 2 seconds). It uses that as the no rotation value. Using a 3 volt gyro should not be a problem for that.

[kgzak]

Originally Posted by Joe Ross

In the gyro open, it measures the average voltage for a period of time (I think I remember 2 seconds). It uses that as the no rotation value. Using a 3 volt gyro should not be a problem for that.

ok. cool. I was worried that it based it on the standard 2.5 volt that the kit encoder uses.