|
|
|
 Good engineering often comes down to knowing the difference between "better" and "good enough." - dlavery [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Good engineering often comes down to knowing the difference between "better" and "good enough." - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: 1/2" Shaft Encoders
We still use the rubber tube method, and it works great. We have a small round cylinder that is the same diameter as the encoder shaft machined into the end of the shaft we want to attach the encoder to. We then use a small piece of rubber tube to attach the shaft to the encoder. This allows the encoder to not be aligned perfectly, and for everything to still work nicely.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
