|
|
|
 I guess what I am trying to say is that GP is inside all of us just waiting for a chance to escape. I am sure how the virus spread. I put the blame solely on the shoulders of Chief Delphi. - Ken Loyd [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
Re: Motor Help Please!
When we turn on the robot, except the RSL Light all of the lights are on.
What does that mean ? Robot just takes the commands from driver station for a moment after we are enabled and then nothing works! |
|
#2
15-02-2011, 15:31
|
||||
|
||||
|
Re: Motor Help Please!
If the RSL light is not on, then it is possible the DSC is not being powered, or is broken. The plug right next to the RSL light should be wired to the Power Distribution Board (PDB) with a 20AMP breaker in place. Go here for a detailed wiring diagram: http://www.usfirst.org/uploadedFiles...%20%281%29.pdf
|
|
#3
15-02-2011, 16:40
|
|||
|
|||
|
Re: Motor Help Please!
I am thinking this may be a programming problem. if the code for your robot is in begin.vi for labview, it will run once and then move on to the next vi, as determined by the main.vi code. move everything but the initialize commands and compressor code into the teleop.vi section of your code. of course, this is assuming you are using labview, and that your code is in begin!
hope this helps. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
