Motor Help Please!

[rsisk]

If the RSL light is not on, then it is possible the DSC is not being powered, or is broken. The plug right next to the RSL light should be wired to the Power Distribution Board (PDB) with a 20AMP breaker in place. Go here for a detailed wiring diagram: http://www.usfirst.org/uploadedFiles...%20%281%29.pdf

[2611.Shooter]

I am thinking this may be a programming problem. if the code for your robot is in begin.vi for labview, it will run once and then move on to the next vi, as determined by the main.vi code. move everything but the initialize commands and compressor code into the teleop.vi section of your code. of course, this is assuming you are using labview, and that your code is in begin!

hope this helps.