|
|
|
 The very fact that parts are rumored to be being re-used may be sufficient reason for the rule-makers to change a rule to prevent the re-use of that very part (not that they would ever be that devious!) - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
15-02-2011, 17:12
|
||||||
|
||||||
|
Re: Analog Module?
See <R61>.
There is no requirement that the analog breakout be connected directly to the NI 9201 module. You could purchase or make a 25 pin ribbon cable and relocate the analog breakout while keeping the 9201 module in slot 1. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode