Autonomous Problem saving power values

First, corndogs and now cowbells... when will you make the pain stop, Frank?!?!?! - barn34 [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
Autonomous Problem saving power values

Thread Tools

Rate Thread

Display Modes

15-02-2011, 18:32

3p1c w1n

Registered User

FRC #1529

Join Date: Jan 2010

Location: Indianapiolis

Posts: 53

3p1c w1n is an unknown quantity at this point

Autonomous Problem saving power values

When opening the Autonomous vi front panel by default all the values are negative. I change them to positive values and run the program on the robot and it works flawlessly. Then I attempt to save it, but it always goes back to the negative. How do you change and save those values?

__________________
~Team 1529 Cybercards~

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 09:17.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.