Problem with LabView Update 3.2 #2

[Doug Norman]

Originally Posted by rclothier

I just installed LabView Update 3.2 #2, and now LabView won't run at all. When I try to launch it, it says "Unable to open resource files." This is a horrible time to have no LabView! Suggestions anyone?

We've heard of this happening when Windows decides to update in the middle of your FRC install. Usually running the FRC update again fixes it. I'm curious how you run the FRC update. Do you unzip it to a folder, and then run the installer?

[dotbran]

Originally Posted by Doug Norman

We've heard of this happening when Windows decides to update in the middle of your FRC install. Usually running the FRC update again fixes it. I'm curious how you run the FRC update. Do you unzip it to a folder, and then run the installer?

I'm having this same problem and the same error message pops up every time I try to install the 3.2 update. I also cannot roll back to 3.1

[Doug Norman]

Originally Posted by dotbran

I'm having this same problem and the same error message pops up every time I try to install the 3.2 update. I also cannot roll back to 3.1

Exactly how are you installing it?

[dotbran]

Originally Posted by Doug Norman

Exactly how are you installing it?

By extracting everything from the .zip archive and running Autorun.

I'll just reinstall LabVIEW.

[cilginbilgin]

Originally Posted by Doug Norman

Exactly how are you installing it?

I unzip everything into another folder and I first run the AutoRun and I run the SetUp.

I have done the update for five times and Labview still doesnt run at all.