Servo Problems

[Businessman41]

I am trying to figure out how to get our servo to work. I plugged it into pwm slot 6 on the digital sidecar plugged into slot 4 of the crio. I opened the servo example in labview, changed the ip address of the crio to the correct address, then ran the code. When I adjusted the control from the labview dashboard that should have set the angle of the sensor, the sensor did not respond. When I try to turn the servo by hand, it turns as if it has no power. The dashboard indicator indicates that it thinks it turned to the correct angle, but there is still no responce from our servo. Help would be greatly appreciated.