|
|
|
 Note to self for next year, apply physics rather than "well, this SEEMS like it would work." - Karibou [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Note to self for next year, apply physics rather than "well, this SEEMS like it would work." - Karibou [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Counter in Labview
I need a way to be able to make a counter in Labview for an arm program. The Idea of the program is to revive a Boolean input from a sensor on the arm and count up these inputs. Any help would be much appreciated!
|
|
#2
19-02-2011, 15:38
|
|||||
|
|||||
|
Re: Counter in Labview
WPI Robotics Library -> Sensors -> Counter
Open a DIO for the switch input, wire its Device Reference through a Digital Source function to a Counter Open, and save the counter's Device Reference using a Refnum Set.
|
|
#3
20-02-2011, 11:31
|
||||
|
||||
|
Re: Counter in Labview
It was right under my nose the whole time, thanks for the help!
But there are multiple modes of the counter, which one is just for a basic count up from a digital input and reset to zero when prompted?
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
