Forward and backward running at only .5 speed

But please, don't attempt to subvert the rules. It almost invariably becomes more trouble than it's worth. - Billfred [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
Forward and backward running at only .5 speed

Thread Tools

Rate Thread

Display Modes

19-02-2011, 21:22

MattCarey3625 MattCarey3625 is offline

#3625 Programming and Wiring Head

FRC #3625 (Some Assembly Required)

Team Role: Programmer

Join Date: Jan 2011

Rookie Year: 2011

Location: Virginia Beach, VA

Posts: 23

MattCarey3625 is an unknown quantity at this point

Re: Forward and backward running at only .5 speed

Try creating an indicator for the front panel so you can see what it is operating at if that doesn't work then try a simple motor control (Open -> SetOutput ||Control-->Close) and then if it still runs at half you can rule out a programming flaw.

__________________
matt@hp-mini-110$> sudo make robot
sudo pass for matt:
unable to make robot

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 01:03.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.