LogoMotion Learnings from Scrimmages

Because when you build the people and the team, building the robot comes much easier. - Koko Ed [more]

		Chief Delphi > FIRST > General Forum
LogoMotion Learnings from Scrimmages

Thread Tools

Rating:

Display Modes

#22

20-02-2011, 11:52

Vikesrock

Team 2175 Founder

AKA: Kevin O'Connor

no team

Team Role: Engineer

Join Date: Mar 2006

Rookie Year: 2007

Location: Manchester, NH

Posts: 3,305

Vikesrock has a reputation beyond repute

Re: LogoMotion Learnings from Scrimmages

Quote:

Originally Posted by GaryVoshol

What specs were violated?
(emphasis mine)

Especially note the nominal dimension for thickness is a minimum, not a maximum.

I read that to mean that the narrowest part (ie. the middle of a triangle edge) of a properly inflated tube should be between 7 and 8 inches, I certainly could be wrong though. If that triangle didn't even fit through the feeding slot as was reported don't you think it may have been on the large side?

__________________

2007 Wisconsin Regional Highest Rookie Seed & Regional Finalists (Thanks 930 & 2039)
2008 MN Regional Semifinalists (Thanks 2472 & 1756)
2009 Northstar Regional Semifinalists (Thanks 171 & 525)

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 22:21.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.