Connecting PWM cables to speed controllers (Jag/vic) is a hassle/problem

[Vikesrock]

You may be doing something incorrectly or the hard way if you are having difficulty inserting the male PWM pins into the Jaguar. In my experience it is much more difficult to assure that the pins actually make it into the receptacles in the Victor than it is in the Jaguar, where the housing is much shallower.

The cable should just plug right into the Jaguar, then you can slide the cable behind the plastic strain relief hook directly in front of the connector. To remove the cable reverse the process, slide the wire out from behind the hook then simply pull it up vertically out of the socket.

Are you sure you are plugging the PWM cables into the right place on the Jaguar and in the correct orientation? Are you using PWM cables that have a different housing than those provided in the Kit of Parts?