Dashboard Help

[1789Robotics]

Well its stays at zero wether the robot is enabled or disabled. All it ever reads is zero.

[Alan Anderson]

Is the

• NI 9201 module installed in Slot 1?
• Analog Breakout attached to NI 9201 module installed in Slot 1?
• jumper properly bridging the two farthest pins of the header at the end of the Analog Breakout attached to NI 9201 module installed in Slot 1?
• white Wago connector of the Analog Breakout attached to NI 9201 module installed in Slot 1 connected to a 20-amp circuit from the Power Distribution board?
• green LED "D2" on the Analog Breakout lit?

And what revisions of the Driver Station and cRIO image are being displayed on the Driver Station diagnostics screen?

[1789Robotics]

We figured out that we had the jumper on backwards. Thanks for the help.