|
|
|
 And you wonder why these guys are figuring out where to hang another Chairman's banner. :) - Billfred [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| And you wonder why these guys are figuring out where to hang another Chairman's banner. :) - Billfred [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
11-03-2011, 22:38
|
||||
|
||||
|
Re: Rookie Team 3729's minibot
Each motor armature has a two inch long 3/8 diameter extension. The extensions are covered in latex tubing and drive directly on the pole. The minbot frame is 8 inch by 3 1/2 inch 1/16 thick Lexan. There are two pieces of 6 inch long 1/2 inch aluminum tubing attached to the frame that guide the minibot off the deployment tray. The only other components are two lamp switches and the Tetrix battery.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode