Go to Post It is sad when the robots do not perform as we designed them. It is sadder still, when they perform well, but they are not victorious. However, it is most saddening when they win at a competition, and competitors are unwilling to acknowledge the teamwork and good fortune of the alliance. - Bill Moore [more]
Home
Go Back   Chief Delphi > Technical > Technical Discussion
Reload this Page Direct drive minibot - output diameter?
CD-Media   CD-Spy  
portal register members calendar search Today's Posts Mark Forums Read FAQ rules

 
 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
  #3   Spotlight this post!  
Unread 16-03-2011, 19:12
NOV8R's Avatar
NOV8R NOV8R is offline
Registered User
AKA: Chuck Brant
FRC #1583
Team Role: Mentor
  
Join Date: Jan 2007
Rookie Year: 2006
Location: Centennial, Colorado
Posts: 209
NOV8R has much to be proud ofNOV8R has much to be proud ofNOV8R has much to be proud ofNOV8R has much to be proud ofNOV8R has much to be proud ofNOV8R has much to be proud ofNOV8R has much to be proud ofNOV8R has much to be proud of
Re: Direct drive minibot - output diameter?
3/8 inch is good. Remove the spur gear . The motor shaft is 2.5 mm. A two inch long piece of 6061 drilled with a 3/32 bit can then be carefully pressed on with thread locker.
 

« Previous Thread | Portal | Next Thread »

Thread Tools
Display Modes Rate This Thread
Threaded Mode Threaded Mode
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 10:50.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.

Contact Us - Chief Delphi - Rules - Archive - Top

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi