Quote:
Originally Posted by mutantblond
we're initializing s1(8,1), s1(8,2). i'm still puzzled about how this works when we've got the solenoid valves connected to pins 7 and 8.
|
the constructor takes two arguments, (modulePort, breakoutPort)
modulePort is the number of the module in the crio's 8 bays. It should be 8.
breakoutPort is the pin number on the breakout board on the module. It should be 7 and 8 according to what I think you are saying.
If you want to wire to 7 and 8, use s1(8,7), s1(8,8)
if you want to use s1(8,1), s1(8,2), wire to breakout pins 1 and 2
Engineering is so much easier when you give all the components personalities. Then you just watch the drama unfold and try to fix it. - EricVanWyk [more] 
Linear Mode
