Help the field crew, reset your gyro in autonomous

[Dave Scheck]

Originally Posted by Chris Hibner

We're considering adding a gyro for backup heading. We were thinking of putting in an LED to let us know when the calibration is complete, but we weren't sure if there's anything in LabVIEW that tells us when it's complete (i.e. how do we know when to turn on the LED?).

Joe mentioned above that the gyro open is a blocking call. Could you wire the output of that (or use one of those fancy flow blocks..I'm a Labview n00b ) to something that activates the LED?

[Chris Hibner]

Originally Posted by Dave Scheck

Joe mentioned above that the gyro open is a blocking call. Could you wire the output of that (or use one of those fancy flow blocks..I'm a Labview n00b ) to something that activates the LED?

Yeah, I know that now - before Joe's answer I didn't know if it was a parallel task.

As it turns out, since the gyro open is blocking, I shouldn't need to do anything. The default code flashes USER 1 LED in PeriodicTasks.vi. PeriodicTasks.vi won't run until Begin.vi completes. So... as long as open gyro is done in Begin.vi (which is where it should be), USER 1 LED will not start flashing until the gyro cal is complete. Yea for simplicity.

[Vikesrock]

I just had a thought that I figured I would throw out there.

What about using a Driver Station input to trigger the Gyro Open in Autonomous Disabled? Then the gyro bias can be calculated during team introductions.

[boomergeek]

This is an important issue as more teams are using the gyro.

We are thinking of adding a relatively quiet but noticeable buzzer that will turn on for 8 seconds- the last 2 seconds we will use to initialize the gyro.

If the field crew is moving the robot when the buzzer sounds, they know they have a few seconds to stop moving the bot- if they don't, they at least know that they should reset the cRIO.