Solution: Variable position of cylinder in compliance with <R74>

[PAR_WIG1350]

*palm--> *

[Roboman01]

Originally Posted by wilsonmw04

Center locking valves are not allowed this year, that's the whole purpose of this crazy thread.

No, the valves themselves are, if you hook them up so that you can release all stored pressure.

*Sigh*, this is going around in circles. I'll have a video up next week demonstrating that there isn't any stored pressure with my system, and I'll talk to an inspector at St. Louis for further confirmation.

[PAR_WIG1350]

Originally Posted by Roboman01

No, the valves themselves are, if you hook them up so that you can release all stored pressure.

*Sigh*, this is going around in circles. I'll have a video up next week demonstrating that there isn't any stored pressure with my system, and I'll talk to an inspector at St. Louis for further confirmation.

that's what this is.

[Roboman01]

that's what this is.

Precisely. After all, that was the entire point of the schematic...

[PAR_WIG1350]