|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#18
|
||||
|
||||
|
Re: Arduino and LabVIEW
Setting a TRUE output on a DIO slot sends 5V of power down the wire. That's one bit, not 32. He's planning on using four DIO slots to send 4 bits of data to the arduino.
Just a note, you can put the PWM cable in sideways on the signal so you use two cables instead of four. Can you put a multimeter on the slots? Can you post the arduino sketch? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|