|
|
|
 What? Thinking is required? I certainly hope not! If so, I'm toast! - Robert Cawthon [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| What? Thinking is required? I certainly hope not! If so, I'm toast! - Robert Cawthon [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
05-12-2001, 23:14
|
|||
|
|||
|
Hole Spacing
When the 'bot blockers were made, the students measured all holes to be 9.25" apart on center, and the center of the end holes was 9.25" from the end of the blocker. The actual drilling, however, had a few that are a little off (less than .25" error); most are very close to that spacing.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| worst experience | mike pawlak | Chit-Chat | 15 | 06-12-2004 07:04 |
| Team 1072 (Harker Robotics Team)'s bot: Tork | AlbertW | Robot Showcase | 8 | 19-02-2003 13:19 |
| what did people think of my teams bot this year (263) | Rob Colatutto | General Forum | 8 | 22-05-2002 19:03 |
| Multiple Regional Winners and a little jab | JamesJones | General Forum | 32 | 10-04-2002 23:38 |
| Team 524's bot | Amadkow | Robot Showcase | 2 | 27-02-2002 20:36 |
Threaded Mode