Direct drive minibot - output diameter? - Chief Delphi

Go to Post

"Its never too late to be inspired" - Alex Golec [more]

Home

		Chief Delphi > Technical > Technical Discussion
Direct drive minibot - output diameter?

Mark Forums Read

Rate Thread

Prev

Previous Post

Next Post

Next

#16

Spotlight this post!

Unread

12-04-2011, 13:37

AlDee

AlDee is offline

Registered User

FRC #1099

Join Date: Mar 2011

Location: Connecticut

Posts: 31

AlDee is an unknown quantity at this point

Re: Direct drive minibot - output diameter?

Quote:

Originally Posted by DonRotolo

View Post

We also removed the brass gear and drilled our shaft with a #40 drill bit. A lathe was used to ensure concentricity of the hole to the shaft. We used the flatted tetrix shaft.

Any reason you chose the flatted shaft? I would think the round shaft would be better for balance at high speed.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 15:23.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.