|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Gyro power
I am contemplating using the gyro on our robot, so I was looking at how to wire it. We have the analog breakout board powered with 12 volts, but the gyro said it requires 5 volts. When I opened and looked at the labview example, it implied that the analog breakout board would step down the current for the gyro. Is this true or do I need to do another method of wiring?
|
|
#2
|
|||||
|
|||||
|
Re: Gyro power
|
|
#3
|
|||
|
|||
|
Re: Gyro power
To answer the question, yes, it is true. The breakout automatically converts the incoming 12V to 5V for you.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|