P60 Gearbox

[Bob Steele]

Which motor are you using?

[aechmtwash11]

****Scratch****550's sorry forgot to add that ****End Scratch****

Actually as long as you have a P60 gearbox we have the back-plate for the 550 motor we are using

[Kevin Sevcik]

Are we to assume that you're heading to the Championship and need the gearbox there?

If so, I've got a spare 1:256 RS775 gearbox I could lend you. I'll hunt around a little more in our parts and see if I can turn up the necessary parts to whip up something closer to a 1:132, but I think we mostly have 1:4 stages at this point.

Exactly what all is broken on your gearbox? We ordered parts ala carte from BB and they had an amazingly short leadtime. You might just order a new front block + shaft from them and whatever new gears you need.

[M.Wong]

Originally Posted by Kevin Sevcik

Are we to assume that you're heading to the Championship and need the gearbox there?

If so, I've got a spare 1:256 RS775 gearbox I could lend you. I'll hunt around a little more in our parts and see if I can turn up the necessary parts to whip up something closer to a 1:132, but I think we mostly have 1:4 stages at this point.

Exactly what all is broken on your gearbox? We ordered parts ala carte from BB and they had an amazingly short leadtime. You might just order a new front block + shaft from them and whatever new gears you need.

I can attest to the short leadtime.

As a side note, are you using the default aluminum body or steel? We had some problems with the body damaging the gears and falling apart until we switched them with steel.

[sanddrag]

Originally Posted by M.Wong

I can attest to the short leadtime.

As a side note, are you using the default aluminum body or steel? We had some problems with the body damaging the gears and falling apart until we switched them with steel.

We noticed the steel ring gear machined quite differently than the aluminum one, with regards to the flats which go up against the roll pins. Some filing of the steel ring gear was needed.

[M.Wong]

Originally Posted by sanddrag

We noticed the steel ring gear machined quite differently than the aluminum one, with regards to the flats which go up against the roll pins. Some filing of the steel ring gear was needed.

The ones we got were fine out of the box.