DLINK Not Communicating with Bridge

[CaptainKemp]

Hello all,

I have my DLINK attached to my robot and the wireless bridge attached to the classmate. I have reset the settings on the Dlink multiple times and have followed the instructions to the letter for configuring it for use.

On the wireless bridge, I have reset it to factory standards and then followed the instructions from the 2010 book for configuring it for use.

The IPs of the system are:
Classmate: 10.8.88.51
Bridge: 10.8.88.4
Dlink: 10.8.88.1

Both the classmate and the DLink have a default gateway of 10.8.88.4

I have turned off all the wireless protection on the DLink, but I cannot connect the Dlink and the Bridge while in wireless. When ethernet connected, they communicate fine and I can ping and run the robot from the DS. When I disconnect, I get nothing.

Can anyone please help me?