Chief Delphi Ventures System

If I was making this I would want to not have to use anything smaller than a 3/16" end mill, but 1/8" would be acceptable. Anything smaller and I'd tell the designer to go play in traffic. - Cory [more]

		Chief Delphi > Announcements
Chief Delphi Ventures System

Thread Tools

Rate Thread

Display Modes

26-11-2002, 09:44

Dante Sparda Dante Sparda is offline

Registered User

#0384 (Team 384)

Join Date: Sep 2002

Location: Richmond, Virginia

Posts: 36

Dante Sparda is an unknown quantity at this point

That sounds really cool, but doesn't it almost influence gambling?

__________________
JR TUCKER SPARKY 384!!! JR TUCKER SPARKY 384!!!
Langley NASA/VCU Regional:
Judges Award winners
Regional Alliance Winners with 388 and 395 (Go 388 and 395!!!)
MAXIMUM SPARKTRAIN!! w007!
Chesapeake Regional:
Regional Alliance Winners with 306 and 134 (Go 306 and 134!!!)

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Chief Delphi Climbs to New Heights ;-)	archiver	2001	0	24-06-2002 04:07
Chief Delphi Institute for Better High School Robotics	archiver	2000	0	24-06-2002 00:17
Chief Delphi Institute for Better High School Robotics	archiver	2000	2	24-06-2002 00:17
Chief Delphi Institute for Better High School Robotics	archiver	2000	0	24-06-2002 00:17
Chief Delphi Institute for Better High School Robotics	archiver	2000	0	24-06-2002 00:17

All times are GMT -5. The time now is 00:24.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.