|
|
|
 Hey Don, if the [Woody Flowers] award doesn't impress the non-FIRST friends and family, just tell them you have your own "inter-web thread" - tell them you are like a Chuck Norris on the internet!!! - ebarker [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#13
27-05-2011, 15:54
|
||||
|
||||
|
Re: How do i wire limit switch
http://www.chiefdelphi.com/forums/at...d=13065256 09
Who to wire IEC Limit Rotary Switch PN: AAP2T51Z11 with the motor TITREX I foind that A 4-wire sensor is designed for use of at least three of the four wires. Wire usage is based on connecting the sensors power (+), common (-), and either a Normally Open (N.O.) or Normally Closed (N.C.)output, or both outputs. The sensor will not operate as a 2-wire device. My Q is whitch nomber should be the (-) of the M- witch nomber is M+ |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode