Rivet

[lemiant]

Originally Posted by M.Wong

If you downloaded the Inventor Content Center Libraries during installation, there should be a ton of different rivets in the Content Center. Metric and Standard of course.

There are lots of pins, but none of them look like pop rivets

[msimon785]

Personally, I just use the plainest STD pin. Generally, I use 0.125" holes and 0.115" pins. It's not perfect, but it serves the purpose and some. It's easy and efficient to accomplish.

[lemiant]

Originally Posted by msimon785

Personally, I just use the plainest STD pin. Generally, I use 0.125" holes and 0.115" pins. It's not perfect, but it serves the purpose and some. It's easy and efficient to accomplish.

At the moment, I am using "By hole", to place the rivets. It works on the original hole, but not any any of the ones created by a pattern.