|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#16
|
|||||
|
|||||
|
Re: Help with CNC "router"
So, if we were to mount a spindle on the "Y" which is really the Z in the current orientation, we'd get very limited travel.
But what if we turned the whole thing over, and hung the Z down below it? We'd still geometrically get the same travel, but do these need to be run in the orientation they were designed for? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|