Looking for a good, cheap gyro

[drakesword]

We found the kit of parts gyro unreliable in the event of an earthquake ...

On a more serious note we had a few issues with the KOP gyro mainly drift and other wierdness, dunno if it was stock code or what but on occasion our robot felt like it was spinning at 5 rads a second.

If you are looking at non-frc gyro then what about one used in R/C helicopters?

[lemiant]

Originally Posted by drakesword

on occasion our robot felt like it was spinning at 5 rads a second.

That kind of drift is not normal, either you gyro is defective or your code is (did you remember to calibrate it?). Our KOP gyro and stock code had less than 0.1deg/sec drift.

[AdamHeard]

Has anyone tried using a more sophisticated gyro with thermal compensation and filtering onboard, interfaced over the I2c port?

[Joe Ross]

Originally Posted by AdamHeard

Has anyone tried using a more sophisticated gyro with thermal compensation and filtering onboard, interfaced over the I2c port?

Unless the gyro has built in integration, it would take a lot of I2C traffic to sample it at a high enough rate, and you'd have to write your own routine for integration.

[SavtaKenneth]

Originally Posted by Joe Ross

Unless the gyro has built in integration, it would take a lot of I2C traffic to sample it at a high enough rate, and you'd have to write your own routine for integration.

Integrating the gyro is very doable. We did it in 2010, I believe I still have the code (In Java) somewhere. However it was an analog sensor, I never got to work with an I2C one.

On the subject we also have a good experience with the KOP gyro.

[davidthefat]

Originally Posted by drakesword

We found the kit of parts gyro unreliable in the event of an earthquake ...

On a more serious note we had a few issues with the KOP gyro mainly drift and other wierdness, dunno if it was stock code or what but on occasion our robot felt like it was spinning at 5 rads a second.

If you are looking at non-frc gyro then what about one used in R/C helicopters?

Check if both of your speed controllers have the jumpers in the right configuration. One year, we had that problem, I thought it was just the chains or something. But it turns out one speed controller was configured to "brake" and the other to "coast".

[jamie_1930]

I found these real quick although the second one is an SMD
http://www.robotshop.com/pololu-dual...t-board-2.html
http://www.sparkfun.com/products/9445
These were the cheapest I could find, but if you want to look at sensors these are the sites I usually use
http://www.robotshop.com/
http://www.sparkfun.com
http://www.makershed.com/
http://www.adafruit.com/

Hope that helps