Chassis - Team 772 2011 off-season (update)

[akoscielski3]

Originally Posted by Akash Rastogi

No, this is probably a bad idea. You want support through all the material of the wheel to the end of the gearbox output shaft on a bearing. It is definitely much easier to use a wheel or attach a hub that allows the output to go through the wheel and rest of a bearing.

I cant find a bigger shaft than this one. I already have the biggest from andymark. How can i find a bigger one? I can try to make it smaller inbetween the wheel and frame too, but i dont think it will be long enough.

EDIT: It will fit but it will be extremely close. About 0.03" clearance