Articulating tubes on roller claws

My suggestion is to first focus in on your drive base. Get it running, and drive it into the ground and see what breaks. Then fix it. Rinse wash and repeat. - Andy A. [more]

		Chief Delphi > FIRST > General Forum
Articulating tubes on roller claws

Thread Tools

Rate Thread

Display Modes

14-09-2011, 23:23

Andrew Lawrence

Posts: n/a

Articulating tubes on roller claws

I know that I've seen teams articulate tubes to a desired angle, but they used 2 separate motors. Does anyone know of any way to accomplish the same thing but using only one motor?

Thanks!

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 07:46.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.