|
|
|
 When I see stuff like that, sometimes I say, "That's BRILLIANT, why didn't I think of that?" But I never like the answer.
- dtengineering [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| When I see stuff like that, sometimes I say, "That's BRILLIANT, why didn't I think of that?" But I never like the answer.
- dtengineering [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
What encoders do you use?
Hey Chief Delphi
I have been working on some off season drivetrains, and was wondering what encoders have worked well for you? I want to be able to hook them up to the wheels to track speed. Thanks, Michael |
|
#2
15-09-2011, 23:24
|
|||||
|
|||||
|
Re: What encoders do you use?
The KOP encoders have always worked well for us...
|
|
#3
15-09-2011, 23:32
|
||||
|
||||
|
Re: What encoders do you use?
|
|
#4
15-09-2011, 23:58
|
|||||
|
|||||
|
Re: What encoders do you use?
Quote:
|
|
#5
16-09-2011, 02:31
|
||||
|
||||
|
Re: What encoders do you use?
If you want to measure wheel speed, the KoP encoders should work fine. They attach easily to most AndyMark gearboxes. Magnetic (absolute) encoders won't be as suited to the job, since you would need to differentiate the angle measured, where as with the optical encoders you can just count.
|
|
#6
16-09-2011, 07:57
|
||||
|
||||
|
Re: What encoders do you use?
Quote:
Install E4P US Digital Encoder onto AndyMark toughbox gearbox: http://www.youtube.com/watch?v=4hJfzhxZwKw Beware the encoder rate bug in the FPGA: http://www.chiefdelphi.com/forums/sh...2&postcount=71 http://www.chiefdelphi.com/forums/sh...74&postcount=6 http://www.chiefdelphi.com/forums/sh...01&postcount=4 |
|
#7
16-09-2011, 08:27
|
|||
|
|||
|
Re: What encoders do you use?
If you want to be cheap, use a hal effect bi-polar latch. We had a situation where mounting a shaft encoder was not nice. We attached a diametrically magnetized neodymium disc magnet to the end of the cim shaft and then mounted a Melexis US4881LUA within 3/8" of the magnet giving a non-contact Tachometer. $1.30 for 10 pieces. Used a male-female PWM cable and soldered it and a pull up resistor onto the male ends. Have to switch some pins. This will not give direction like a quadrature encoder. Can be used to give counts for distance and with a little more code velocity. Use the counter VI. Cheap non contact sensing.
|
|
#8
16-09-2011, 10:35
|
||||
|
||||
|
Re: What encoders do you use?
Okay thanks everyone!
Michael |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
