Using plaction wheels on a roller claw

Now, I either need to convince Mike Martus to start the webhug early (or move it back 1 hour), skip the webhug, miss the first part of the presentation, or just clone myself. - Andy Baker [more]

		Chief Delphi > Technical > Technical Discussion
Using plaction wheels on a roller claw

Thread Tools

Rate Thread

Display Modes

#19

16-09-2011, 12:58

ajlapp

Registered User

AKA: Anthony Lapp

None #0118 (Team RUSH and Robonauts)

Join Date: Sep 2001

Rookie Year: 1996

Location: Ortonville, MI

Posts: 648

Re: Using plaction wheels on a roller claw

We used the variety linked below....we chose them based on a subjective analysis of grippyness on the tubes. Plus they're low cost and we were able to push a 3/8" hex broach through them with relative success.

http://www.vexrobotics.com/products/.../276-1496.html

http://www.chiefdelphi.com/media/photos/36542

__________________
Anthony Lapp
FIRST Engineering Mentor
Owner/Operator 221 Robotic Systems
221 Robotics Systems - Quality Hardware, Made in the USA
RobotOpen
anthony@221robotics.com
Twitter us: @221RobotSystems
Team 1 --> 94 --> 68 --> 221 --> 857 --> 27 --> 118
Design Engineer/Fabricator and 17 year vet
Team Rush (FRC27) and Robonauts (FRC118)

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 14:33.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.