|
|
|
 It takes a village to raise a robotics student... - Bob Steele [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It takes a village to raise a robotics student... - Bob Steele [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
22-09-2011, 18:12
|
||||
|
||||
|
Re: Interfacing the Digital Sidecar
It is certainly possible. All of the GPIO lines are simply pulled high within the DSC (the same as on board the Arduino) and the PWM lines are buffered. Basically, you can ignore all that and pretend that they are all direct connections. The relay outputs are controlled by a serial communication line, if you want to use those, you will have to figure out the serial protocol.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode