|
|
|
 Pursue your passion whatever that may be and do not fault another for pursuing theirs. - Mr. Van [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| Pursue your passion whatever that may be and do not fault another for pursuing theirs. - Mr. Van [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#16
13-10-2011, 13:39
|
||||
|
||||
|
Re: Autodesk Inverter Pro 2012 - MasterCAM - CNC
Cory,
Everything you mentioned is spot on. Some of it I just figured out this morning. The absolute thing was driving me nuts for a while. Another problem I had is, when you extrude parts in Inventor, you have to be very careful as to whether you extrude in, out or from the middle of the 2D drawing as MasterCAM seems to pick the surface based on that plane. The other depth settings you mentioned seem to be under Toolpath >> Parameters >> Linking Parameters. I had to play with that quite a bit this morning as well. Thanks again, Doc 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode