Can't deploy from netbeans or eclipse

[linuxboy]

Try eliminating as many network devices / complication as possible between the computer you are trying to deploy from to the cRIO. I would recommend either a crossover from the cRIO to the laptop or a single normal switch between the two, with straight cables to the switch from each. Also, see if you can ftp manually to the cRIO from one of the connected computers with the IP Address 10.xx.yy.2, with xx being the first two digits of your team number and yy being the last two digits, so for my team, its 10.37.80.2, and the username anonymous, no password. If that doesn't work could you post the actual error that netbeans spits out?

Oliver

[Joe Ross]

Did you set the team number in netbeans?

[plnyyanks]

Originally Posted by linuxboy

... connected computers with the IP Address 10.37.80.2 ...

Actually, .2 is the IP for the cRIO, not a computer, and remember to change the IP scheme to reflect your team number (10.xx.yy.zz, where xxyy is your team number). Your computer would need to be: 10.35.60.7 (or something greater than .5), and your cRIO needs to be 10.35.60.2.

For a nice diagram/table of the proper IP addresses, look here (note: it's an old document, from 2009. but the IPs haven't changed). Look at Section 5.2/Page 6.

[linuxboy]

Originally Posted by plnyyanks

Actually, .2 is the IP for the cRIO, not a computer, and remember to change the IP scheme to reflect your team number (10.xx.yy.zz, where xxyy is your team number). Your computer would need to be: 10.35.60.7 (or something greater than .5), and your cRIO needs to be 10.35.60.2.

For a nice diagram/table of the proper IP addresses, look here (note: it's an old document, from 2009. but the IPs haven't changed). Look at Section 5.2/Page 6.

Right, by connect with, I meant use that IP to connect to cRIO.

Oliver