|
Re: Press Fit
Because my team's equipment was not more accurate, I always went 0.001" under and put a generous chamfer on the hole to help in pressing the bearing in.
You could also aim for a close fit and glue the bearings in or peen them in. I've had good luck peening in flanged bearings.
__________________
Theory is a nice place, I'd like to go there one day, I hear everything works there.
Maturity is knowing you were an idiot, common sense is trying to not be an idiot, wisdom is knowing that you will still be an idiot.
|
I would not want the task of devising a system that 50,000 very smart people try to outwit. - texarkana [more] 
14-12-2011, 08:46
Threaded Mode