Press Fit - Chief Delphi

Good engineering often comes down to knowing the difference between "better" and "good enough." - dlavery [more]

		Chief Delphi > FIRST > General Forum
Press Fit

14-12-2011, 08:52

Jared Russell Jared Russell is offline

Taking a year (mostly) off

FRC #0254 (The Cheesy Poofs), FRC #0341 (Miss Daisy)

Team Role: Engineer

Join Date: Nov 2002

Rookie Year: 2001

Location: San Francisco, CA

Posts: 3,078

Re: Press Fit

If you use flanged bearings and then trap them with spacers/collars/nuts/snap rings, you can get away with a pretty sloppy slip fit.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:55.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.