Calabrating the servos - Chief Delphi

I don't know how much of a safety factor chain manufacturers build into these ratings. I've got empirical evidence to demonstrate that it's not 5, however. - Tristan Lall [more]

		Chief Delphi > Technical > Motors
Calabrating the servos

Thread Tools

Rate Thread

Display Modes

14-12-2002, 20:30

rust710

Registered User

#0862 (Lightning Robotics)

Join Date: Dec 2002

Location: Canton, MI

Posts: 103

rust710 is an unknown quantity at this point

Ok, I will check it against a good servo. Thanks for you help.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Creative uses for servos?	dddriveman	Motors	34	19-07-2003 00:33
servos	Alex Cormier	Kit & Additional Hardware	1	14-01-2003 11:12
Can RC servos be used with EDUbot?	ChrisH	Technical Discussion	4	31-12-2002 01:45
Need help in creating program to use servo's to shift drive	archiver	2001	19	24-06-2002 00:35
servos, chapulas, cylinders and Skyway...in other words...	Jessica Boucher	Motors	7	14-01-2002 19:36

All times are GMT -5. The time now is 22:48.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.