pic: Team 3647 West Coast Drive

By the end of week six, I'm sick of looking at the robot enough that stuffing it in a bag is rather cathartic...:rolleyes: - 2544HCRC [more]

		Chief Delphi > ChiefDelphi.com Website > Extra Discussion
pic: Team 3647 West Coast Drive

Thread Tools

Rating:

Display Modes

#16

16-12-2011, 11:19

craigboez

Mechanical Engineer

AKA: Craig Boezwinkle

FRC #2811 (StormBots)

Team Role: Mentor

Join Date: Oct 2008

Rookie Year: 2009

Location: Chicago, IL

Posts: 217

Re: pic: Team 3647 West Coast Drive

Quote:

Originally Posted by Mk.32

Someone asked for a photo of the bearing block, here it is.
Two 500 Hex Bearings press fit into 1/4 alum plates.
Bolt holes are pocketed so it slides about .25inch to allow for tensioning.

[/img]

Neat design. How do you keep the two plates aligned with each other and the shaft perpendicular to the frame?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 20:37.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.