Center Drop on 6WD 1/8 or 1/16

[Gray Adams]

Originally Posted by compwiztobe

What type of wheels did you use?

We have done 1/8" drop with 6 plaction wheels. We had no difficulty turning, but the rock was certainly noticeable. Depending on what else the robot is doing this may or may not be a problem.

We used AM 4" performance (with rough top). There's noticeable tread wear on the outer wheels as compared to the center wheels as well from the excessive dragging.

Side note: The Andy Mark CAD for the wheels shows less material around the center than the actual wheel has. Not a huge problem, but it did cause some surprises when we got our hands on the wheels.