|
|
|
 Most people who say "winning doesn't matter" have not won enough to have a balanced opinion on the issue. - T^2 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Most people who say "winning doesn't matter" have not won enough to have a balanced opinion on the issue. - T^2 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
pic: Team 2220 traditional 6 wheel drive
Center drop: 1/8" I know there are a couple problems with it already. Using the extended output shaft, we still don't have enough room in the wheel well to run 2 loops of chain. Other than machining a longer outputshaft, are ther other easy fixes? Also, I am not completely familiar with how to use some of the stuff from Andymark: do I need to use 2 hubs on the driven wheel, or do I just need a hub on one side? If I only need one hub, I think we can make the chains fit, but it will still be close. Are the gussets enough to keep it square? Are there any other problems I should be aware of? Last edited by Alex.q : 02-01-2012 at 12:43. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode