|
|
|
 To ANY Robowrangler students reading this thread:
If any of you ask me about the game hint, at any time, you will be assigned 4 hours of shop cleaning duty during week 1. No exceptions. - JVN [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
04-01-2012, 12:32
|
|||||
|
|||||
|
Re: pic: Unobtainium 6wd - Cantilevered, Dead-Axle, Slot-Tensioned Drivetrain
Stover lock nuts, you mean?
I suggest you might want to find or figure out how to make a more substantial washer. Our design used large hex flanged nuts. You might be able to do this too, and use 1/2" fine thread threaded rod for the axle as we did. We used two jam nuts to retain the wheels, but this required that whoever was working on the robot needed to know not to tighten the nut too much!  Last edited by MrForbes : 04-01-2012 at 12:37. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode