|
Re: Bumper zone height
R33 says:
Quote:
|
Bumpers must be supported by the structure/frame of the Robot (i.e. the gap between the backing material and the frame must not be greater than ¼ in. and no section of Bumper greater than 8 in. may be unsupported). See Figure 4‑7.
|
I would interpret this as saying that for a bumper to be supported, the gap between the bumpers and the frame must be 1/4 in. or less. The right picture would then be OK because the bumper is supported over that length.
__________________
Congratulations Ben Senson on winning the 2012 Wisconsin Regional Woodie Flowers Finalist Award!
2012 Wisconsin Regional Semifinalist
2012 Wisconsin Regional Engineering Inspiration Award
2011 Wisconsin Regional Innovation in Control Award
2010 Wisconsin Regional Chairman's Award
2010 Wisconsin Regional Quarterfinalist
2010 Curie Division Quarterfinalist
|
Anyways, before we all get worked up over this setup, let's wait and see what details emerge. It can't be as bad as everyone is making it seem. - Karthik [more] 
08-01-2012, 11:41
Threaded Mode