|
|
|
 Inventing rocks. I think we've all learned that through FIRST. - Billfred [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Inventing rocks. I think we've all learned that through FIRST. - Billfred [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Can't make Robot project on new LabView Software
Trevor (Pi Fighter) is right.
We installed on 4 different computers last night, and I reinstalled 3 times today. The USB drive auto-run is not installing anything FRC related except the license. Indeed, if you double click the driver station installer, it tries to install only the vision component of labview. No driver station. 
|
|
#2
08-01-2012, 12:56
|
|||
|
|||
|
Re: Can't make Robot project on new LabView Software
I ironically don't have a USB drive to test with. It shouldn't be necessary, but perhaps you could try to uninstall the driver station from the laptop, then install from the USB. I have seen situations where one of the version numbers was incorrect, and the installer essentially decides not to update files.
Greg McKaskle
|
|
#3
08-01-2012, 15:33
|
||||
|
||||
|
Re: Can't make Robot project on new LabView Software
It did this on a clean computer (a new one with no labview), on 2 computers that had labview uninstalled completely, and on one where we did not uninstall labview.
Installing from the updates page that Joe Ross posted put most of the stuff where it should be, but I haven't had time to check the driver station. We spent too much time today playing basketball in the gym.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
