|
|
|
 Not even close to ready...can we delay it till like...January 2010? - Cory [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Not even close to ready...can we delay it till like...January 2010? - Cory [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
08-01-2012, 19:09
|
||||
|
||||
|
Re: Bumper question
I've attached an image from Figure 4-3.
Why is the circled corner not ok? Is it because a) it is an interior vertex and cannot be bumper-ed, b) the adjacent exterior vertex is not covered c) the straight section of frame connecting it to the exterior vertex is less then 8'' To me it seems like they are saying you can't have a bumper go inside a cut-out. Which is odd. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode