Can't make Robot project on new LabView Software

[Belenus]

Originally Posted by Pi Fighter

We've tried installing from the thumb drive four times, yet we do not have the driver station, or the ability to create a FRC Robot Project.

And to those below him, did you try to install the update that was listed above, I know you need it to make the robot project, and from looking over the install files and what it installed the Driver_Station_Setup.exe is only the Vision Software.

Also for those having issues with the USB Installer I would would say try to copy the files over the the PC then install from there. When we tried to install the files from the USB the smallest of hit to the USB drive or PC would stop the Install. When I copied the files over it installed just fine.

[s.Potter]

I have installed the update for labview and I still only have the options to install a blank project and a real-time project. i have tried the update at lest 3 time now and it does not change anything. I also had trouble to get labview on to my computer that is not the classmate. the installer would run get to the end and not installed labview. so i took it off of the classmate and labview runs but it does not have all if any of the FRC VI's on it. any help would be much appreciated.